Table of Contents
Advertisement
P0335-CRANKSHAFT POSITION SENSOR CIRCUIT —
TEST
15
Turn the ignition off.
Disconnect the CKP Sensor harness connector.
Ignition on, engine not running.
Measure the voltage on the (K6) 5 Volt Supply circuit in the CKP Sensor harness
connector.
Is the voltage above 5.5 volts?
Yes → Repair the short to battery voltage in the (K6) 5 Volt Supply
→ Go To 16
No
16
NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
Repair
ACTION
circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
129
Continued
APPLICABILITY
All
All
Advertisement
Table of Contents
