Mode 5: See Figure 2
Same as mode 2 except that the power on is controlled by remote switch.
A. Power on is controlled by remote switch (ignition must be turned on 2 seconds
before remote switch is pressed).
B. The Smart Mode sends off pulse to motherboard 5 seconds after ignition is turned off
or remote switch is pressed. (Soft delay)
C. Hard off delay: 1 minutes
Mode 6:
A. Same as mode 5 except for soft/hard off and delay
B. Soft off delay: 1 minute
C. Hard off delay: 5 minutes
Mode 7:
A. Same as mode 5 except for soft/hard off and delay
B. Soft off delay: 30 minute
C. Hard off delay: 2 Hours
Mode15(Software control mode):
A. Setting by AP
B. Software mode default as Hardware mode 2
C. Soft off delay time can be set
D. Hard off delay time can be set
E. In-Vehicle system power on by ignition or Remote button can be set
F. Show Ignition status / Voltage(for AP only)
G. Create a button "Set default"
Plan AP screen
Engine status
System on by
Ignition
Soft off delay time
Hard off delay time
37
Car Battery
Remote Switch
seconds
Set Default
seconds
OK
Cancel
Revision: 1.0