Revision :1.0 1. Introduction to AR-ES5430FL AR-ES5430FL is a system product mainly for ticket control, navigation, advertising, fleet managements applications. With fanless & dust-proof design, AR-ES5430FL can satisfy the user requirements in any application environment. AR-ES5430FL has diverse physical interface in the front panel, such as pluggable CF card, KB/MS connector, 2 USB Ports, 2 10/100/1000 LAN ports, VGA port, 4 console ports, LVDS port, DVI port, Audio output, External Switch Jack, Power Switch, Input Power connector.
Revision :1.0 2. Procedure of Assembly/Disassembly 2-1 Installing the 2.5” Hard Disk Drive (HDD) The following are procedure for install 2.5”HDD device 1. Remove bottom door screws (2pcs) in system bottom case Insert the rubbers into the HDD bracket for each edges...
Page 6
Revision :1.0 2. Lock HDD and Bracket together via screws (4pcs) 3. Plug the HDD cable into the 44-pin header connectors in main board...
Page 7
Revision :1.0 4. Remove right side door screws (2pcs) in system bottom case 5. Route the HDD cable through the main board 6. Lock right side door screws (2pcs) in system bottom case...
Page 8
Revision :1.0 7. Lock HDD bracket to the top case by four screws 8. Insert HDD cable into the HDD module 9. Lock the door screws in system bottom case...
Revision :1.0 2-2 Installing CF card The following are procedure for install CF card 1. Remove screws (2pcs) in CF card bracket 2. Install CF card to the bracket 3. Insertion CF card to CF card expansion slot 4. Lock the bottom door screws...
Revision :1.0 2-3 Installing SO-DIMM The following are procedure for install SO-DIMM 1. Remove HDD out from the system 2. Install the SO-DIMM into the SO-DIMM socket...
Revision :1.0 3. Re-Install HDD device 4. Lock the bottom case Door screws 2-4 Installing the 2.5”SATA Hard Disk Drive(HDD)(Option) The following are procedure for install 2.5”HDD device Remove bottom door screws (2pcs) in system bottom case Insert the rubbers into the HDD bracket for each edges...
Page 12
Revision :1.0 Lock HDD and Bracket together via screws (4pcs) Plug the HDD cable into the power and signal header connectors in main board...
Page 13
Revision :1.0 Remove right side door screws (2pcs) in system bottom case Route the HDD cable through the main board Lock right side door screws (2pcs) in system bottom case Lock HDD bracket to the top case by four screws 10.