Fltr Page (Cc Value); Amp Page (Cc Select) - Elektron Digitakt User Manual

12. MIDI TRACK PARAMETERS
12.3.1 CHAN
Channel sets the MIDI channel the track will send MIDI data to. If this parameter is set to OFF, it basically
turns the MIDI track off. Please note that this parameter cannot be parameter locked. (OFF, 1–16)
12.3.2 BANK
Bank is used for sending out a bank change message. Bank 1 to 128 can be sent. (OFF, 1–128)
12.3.3 PROG
Program change is used for sending out a program change message. Program 1 to 128 can be sent.
(OFF, 0–128)
12.3.4 PB
Pitch Bend controls the pitch bend data sent on the MIDI track. (OFF, -128.00–128.00)
12.3.5 AT
Aftertouch controls the aftertouch data sent on the MIDI track. (OFF, 0–127)
12.3.6 MW
Mod Wheel controls the modulation wheel data sent on the MIDI track. (OFF, 0–127)
12.3.7 BC
Breath controller controls the breath control data sent on the MIDI track. (OFF, 0–127)

12.4 FLTR PAGE (CC VALUE)

Here you can set the values of up to eight assignable CC commands. The default value of the parameters
on this page is OFF, meaning they are disabled and will not send out any data. Press and hold [FUNC] and
then press the DATA ENTRY knobs to enable them. You can then use the DATA ENTRY knobs to set the
parameter values as usual. Disable the parameters again by repeating the enabling procedure.
Press [FLTR] to access this parameter page.
12.4.1 VAL1-VAL8
CC 1–8 Value controls the values that are sent for the CC commands, which are specified on the AMP
(CC SELECT) page. These parameters default value is OFF. Press [TRIG] + DATA ENTRY knobs to acti-
vate the parameters and then set a value. (OFF, 0–127)

12.5 AMP PAGE (CC SELECT)

Here you select the eight CC commands whose values are controlled by the parameters on the FLTR PAGE
(CC VALUE) page. Press the corresponding knob or [ENTER/YES] to activate the parameter change.
Press [AMP] to access this parameter page.
44