Switching Input Signal - Casio XJ-L8300HN User Manual

Entering the password recall procedure
1. Press and hold ENTER for 3 seconds. The projector
will display a coded number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local CASIO service center to
decode the number. You may be required to provide
proof of purchase documentation to verify that you
are an authorized user of the projector.
Changing the password
1. Go to SYSTEM SETUP: ADVANCED > Password > Change Password.
2. Press ENTER. The message "Input Current Password" appears.
3. Enter the old password.
• If the password is correct, another message "Input New Password" appears.
• If the password is incorrect, the password error message will appear, and the message
"Input Current Password" appears for your retry. You can press ESC to cancel the
change or try another password.
4. Enter a new password.
5. Confirm the new password by re-entering the new password.
Disabling the password function
To disable password protection, go to SYSTEM SETUP: ADVANCED > Password > Power
On Lock and press
Enter the current password.
• If the password is correct, the OSD menu returns to the Password page. You will not have
to enter the password next time turning on the projector.
• If the password is incorrect, the password error message will appear, and the message
"Input Current Password" appears for your retry. You can press ESC to cancel the
change or try another password.
Though the password function is disabled, you need to keep the old password in hand should you ever
need to re-activate the password function by entering the old password.

Switching input signal

The projector can be connected to multiple devices at the same
time. However, it can only display one full screen at a time.
When starting up, the projector automatically searches for the
available signals.
Be sure the SYSTEM SETUP: BASIC > Auto Input Search
menu is On if you want the projector to automatically search for
the signals.
To select the source:
1. Press INPUT. A source selection bar appears.
2. Press / until your desired signal is selected and press
ENTER.
28 Operation
/ to select Off. The message "Input Current Password" appears.
RECALL PASSWORD
Please write down the recall code,
and contact
Customer Center.
Recall Code:
Exit