Troubleshooting - Casio XJ-L8300HN User Manual

Troubleshooting

The projector does not turn on.
There is no power from the power cord.
Attempting to turn the projector on again
during the cooling process.
No picture
The video source is not turned on or
connected correctly.
The projector is not correctly connected to the
input signal device.
The input signal has not been correctly
selected.
The lens cover is still closed.
Blurred image
The projection lens is not correctly focused.
The projector and the screen are not aligned
properly.
The lens cover is still closed.
Remote control does not work.
The batteries are out of power.
There is an obstacle between the remote
control and the projector.
You are too far away from the projector.
The password is incorrect.
You do not remember the password.
Cause
Cause
Cause
Cause
Cause
Plug the power cord into the AC power jack on the
projector, and plug the power cord into the power
outlet. If the power outlet has a switch, make sure that
it is switched on.
Wait until the cooling down process has completed.
Turn the video source on and check that the signal
cable is connected correctly.
Check the connection.
Select the correct input signal with the INPUT key.
Open the lens cover.
Adjust the focus of the lens using the focus ring.
Adjust the projection angle and direction as well as the
height of the projector if necessary.
Open the lens cover.
Replace both of the batteries with new ones.
Remove the obstacle.
Stand within 8 meters (26 feet) of the projector.
"Entering the password recall procedure" on
See
page 28
.
Remedy
Remedy
Remedy
Remedy
Remedy
Troubleshooting 49