Table of Contents
Advertisement
Introduction
Shipping contents
Carefully unpack and verify that you have all of the items shown below. If any of these items are
missing, please contact your place of purchase.
Standard accessories
• Projector
• Remote control, YT-310
• Cable tie set x 2
• Test batteries (AA-size x 2)
• AC Power cord
• RGB cable
• "Safety Precautions" sheet
• "Read this first" sheet
• Warranty*
• The supplied accessories will be suitable for your region.
• *The warranty card is only supplied in some specific regions. Please consult your dealer for detailed
information.
Replacing the remote control batteries
1. Press on the finger grip on the cover and push it up in
the direction of the arrow as illustrated.
2. Remove the old batteries (if applicable) and install
two AA batteries. Make sure that the positive and
negative ends are positioned correctly, as illustrated.
3. Refit the cover by aligning it with the base and
pushing it back down into position. Stop when it
clicks into place.
• Avoid leaving the remote control and batteries in an excessive heat or humid environment like the
kitchen, bathroom, sauna, sunroom or in a closed car.
• Replace only with the same or equivalent type recommended by the battery manufacturer.
• Dispose of the used batteries according to the manufacturer's instructions and local environment
regulations for your region.
• Never throw the batteries into a fire. There may be danger of an explosion.
• If the batteries are dead or if you will not be using the remote control for an extended period of time,
remove the batteries to avoid damage to the remote control from possible battery leakage.
14 Introduction
Hide quick links:
Advertisement
Table of Contents
