Fujitsu LifeBook E Series Instructions Manual page 91

Problem
Shutdown and Startup Problems
Your LifeBook BIOS setup changes were
notebook appears not saved when you exited
to change setup the BIOS setup utility,
parameters when returning it to previous
you start it.
settings.
The BIOS CMOS hold-up
battery has failed.
Video Problems
The built-in display
Something is pushing on
is blank when you
the Closed Cover switch.
turn on your
The angle of the display
LifeBook notebook.
and the brightness
settings are not adequate
for your lighting condi-
tions.
The LifeBook notebook is
The built-in display
set for an external monitor
is blank when you
only.
turn on your
LifeBook notebook.
(continued)
The power management
time-outs may be set for
very short intervals and
you failed to notice the
display come on and go
off again.
The LifeBook Power On Self Test
(POST) has detected a
notebook turned
on with a series of failure which does not
allow the display to
beeps and your
operate.
built-in display is
blank.
Possible Cause
Tr o u b l e s h o o t i n g
Possible Solution
Make sure you select Save Changes And Exit
when exiting the BIOS setup utility.
Contact your support representative for
repairs. This is not a user serviceable part
Clear the Closed Cover switch.
Move the display and the brightness control
until you have adequate visibility.
Pressing [F10] while holding down the [Fn] key
allows you to change your selection of where
to send your display video. Each time you
press the combination of keys you will step to
the next choice. The choices, in order are:
built-in display only, external monitor only, both
built-in display and external monitor.
Press any button or key on the keyboard, or
move the mouse to restore operation. If that
fails, push the Power and Suspend/Resume
button. (The display may be shut off by Standy
mode, Auto Suspend or Video Timeout.)
Contact your support representative.
81