Fujitsu LifeBook E Series Instructions Manual page 44

L i f e B o o k E S e r i e s - S e c t i o n 3
You can check if memory is installed
correctly and how much memory is
installed on you computer. The memory
capacity of your computer is displayed in
the Memory slot area of the Information
window of BIOS Setup. This windows
shows the size and type of memory
installed, for example, like this: "512MB
DDR SDRAM." If the memor y you
installed makes it impossible for your
computer to start up, the memory may
be faulty or defective. If this happens,
contact or your reseller.
To avoid damage, do not touch internal
components unnecessarily.
To avoid damage, be careful not to drop
a screw or any other part removed into
the computer.
If you want to increase the memory
capacity of your computer to a maximum
(1GB), you might need to remove and
replace the memory module with another.
Installing memory
1. Turn off your computer and disconnect
the AC adapter from it.
2. Remove the internal battery pack.
Perform steps 1 to 3 in the "Changing the
internal battery pack" section.
3. Remove the screw shown in the figure
below, and detach the expansion RAM
module slot cover.
Remove the expansion RAM module slot
cover on the bottom of the computer.
34
4. Install the memory.
Open the slot cover, align the notch in the
memory module with the projection on the
connector, insert the memory diagonally into
the slot, and push down the memory until it
clicks into place.
5. Attach the expansion RAM slot cover and
secure it with the screw.
Attach the cover you removed in step 3, with
the tabs on the cover fitted in the locating
holes in the computer.
6. Install the internal battery pack.
Perform step 4 in the "Changing the internal
battery pack" section.
Standard RAM slot
Expansion RAM slot