Advertisement
6
Add user codes (16 max)
Programming Timeout
During programming, if no button is pressed for five seconds, the system will time out (indicated by
three beeps and a red flashing keypad), and you will need to restart the procedure.
A
Make sure the door is open. Press
the Program button once.
D
What lights and sounds does the lock produce?
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon. See "Switches and Status LED Colors" on page 4.
Mastercode
For enhanced security, a mastercode may be used when adding and deleting user codes. For more information about the mastercode,
download the Programming and Troubleshooting Guide on the SmartCode 913 page at www.kwikset.com.
Test the lock (review normal operation)
7
Confirm that the code(s) added in previous step can unlock the door.
Locking the Door
Press Lock button once.
8
Re-key the lock (if needed) and install the battery cover
A
Re-key the lock (if needed).
a
K
IMPORTANT:
Remove battery
pack before
re-keying.
B
Enter user code. A total of 16 user
codes may be programmed.
One green flash with one beep
green
1x
Programming was successful.
b
Re-key the lock
to work with your
existing key. See
the supplied
SmartKey Re-key
instructions for
more information.
H
C
Each user code
must be a unique
code between 4
and 8 digits.
Three red flashes with three beeps
or
Programming was unsuccessful.
Make sure not to pause for more than 5 seconds during programming.
Make sure the user code is not a duplicate and that it is between 4 and 8 digits
during your next attempt. Make sure the lock has room for an additional code. If
all user code positions are filled, delete a code to make room for this one.
Unlocking the Door
Enter user code.
B
c
K
Reinstall
battery
pack.
3 / 4
Press Lock button once.
red
3x
Install the battery cover.
a
b
M
actual
size
V
V (3x)
Advertisement
