Gardena ComfortCut 450/25 Operating Instructions Manual page 8

Cleaning the trimmer:
s
Replacing the filament
cassette:
f
g
g
h
18
The ventilation slots must always be free of dirt.
v Clean all moving parts after each use, and especially remove
s
any grass and dirt from the cover
0
Risk of injury!
v N ever use metallic cutting elements or replacement
parts and accessories not provided by GARDENA.
Only use original GARDENA Filament Cassettes. You can
d
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
f
• for Art. 9808 / 9809:
GARDENA Filament Cassette for Turbotrimmers
• for Art. 9811:
GARDENA Filament Cassette for Turbotrimmers
1. Press in cassette cover
time and remove.
2. Remove the filament cassette
3. Remove any dirt.
4. Pull approximately 15 cm of the cutting filament
new filament cassette
5. First thread the cutting filament
6. For Art. 9808 / 9809 only: Thread the cutting filament
the guide pin
7. Insert the filament cassette
k
l
holder
p
8. Fit the cassette cover
j
so that you hear both locking clips
For Art. 9808 / 9809 only: When fitting the cassette cover
the cutting filament
and must not be trapped.
v If the cassette cover
l
filament cassette
is completely in the filament cassette holder
d
on the two catches
g
g
through the hole in the plastic ring
k
.
g
into the filament cassette
.
d
on the filament cassette holder
p
must be placed around the guide pin
d
cannot be touched down, turn the
g
to and fro, until the filament cassette
0
and ventilation slots
f
at the same
.
p
out of the
p
through the metal sleeve
p
f
click into place.
l
.
s
.
Art. 5307
Art. 5309
h
.
j
.
around
l
d
,
k
g