Heat Sink - HP Spectre 13-v0 SERIES Maintenance And Service Manual

Heat sink

Description
Heat sink (includes replacement thermal material)
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. WLAN module (see
d. System board (see
Remove the heat sink:
1. Following the 1, 2, 3 sequence stamped into the heat sink, remove the three Phillips PM2.0×3.0
screws (1) that secure the heat sink to the system board.
2. Remove the heat sink (2).
NOTE:
the system board components, it may be necessary to move the heat sink from side to side to detach it.
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system
board each time the heat sink is removed. Replacement thermal material is included with the heat sink and
system board spare part kits. Thermal paste is used on the heat sink (1) and on the system board (2) as
shown in the following image.
Bottom cover on page
Battery on page
Solid-state drive on page
WLAN module on page
System board on page
Due to the adhesive quality of the thermal material located between the heat sink and
24), and then remove the following components:
26)
28)
29)
35)
Spare part number
854752-001
Component replacement procedures 37