Data Transfer With Simatic Memory Cards - Siemens Simatic ET200pro Operating Instruction

8.3

Data transfer with SIMATIC memory cards

Transferring objects from the project to a SIMATIC memory card
When the SIMATIC memory card is inserted in the programming device or external card
reader, you can transfer the following objects from the project tree (STEP 7) to the SIMATIC
memory card:
● Individual blocks (multiple selection possible)
In this case, the transfer is consistent, i.e. the function takes dependencies between
blocks due to block calls into account.
● CPU folder
In this case, all runtime-relevant objects including blocks and the hardware configuration
are transferred onto the SIMATIC memory card - just as when downloading.
● Service data
In this case, the service data saved beforehand (see section Reading out/saving service
data (Page 111)) is transferred to the memory card.
To perform a transfer, you can transfer the objects by drag-and-drop or use the "Card
Reader/USB memory > Write to memory card" command in the "Project" menu.
Firmware update via SIMATIC memory card
You can find information on how to perform a firmware update via SIMATIC memory card in
the section Firmware update (Page 98).
Reference
You can find additional information on theSIMATIC memory card in the STEP 7 online help.
CPU 1516pro-2 PN (6ES7516-2PN00-0AB0)
Operating Instructions, 09/2016, A5E35873416-AA
8.3 Data transfer with SIMATIC memory cards
SIMATIC memory card
97