Ejecting And Inserting Psu; Ejecting A Psu; Inserting A Psu - Ganz ZA-NVE40K Hardware Manual

ZA-NVE40K Hardware Manual

4.7. Ejecting and inserting PSU

Ejecting a PSU

1. Unscrew four collar screws.
2. Grasp the inject/eject handle of the PSU and push it down as shown in below figure.
3. Remove the PSU from the rack.
Figure 12. Ejecting a PSU

Inserting a PSU

1. Make sure that the inject handle is in the outward position.
2. Insert the PSU into the rack.
3. Grasp the inject handle of the PSU and pull it up.
4. Screw four collar screws.
2010/2-1 D 18