Inserting A Blade; Factory Default Settings - Ganz ZA-NVE40K Hardware Manual

ZA-NVE40K Hardware Manual
1. Unscrew four collar screws.
2. Grasp the inject/eject handle of the blade and push it down as shown in below figure.
3. Remove the blade from the rack.

Inserting a blade

1. Make sure that the inject handle is in the outward position.
2. Insert the blade into the rack.
3. Grasp the inject handle of the blade and pull it up.
4. Screw four collar screws.

3.5. Factory Default Settings

Factory default settings are as follows:
• IP address: 192.168.xx.yy (refer to 2.3 Serial Number / MAC Address)
• Mask: 255.255.0.0
• Gateway: 192.168.0.1
• User ID: root
• Password: pass
MAC address = 00-1C-B8-C0-14-B1 → IP address = 192.168.35.69
Factory Default (FD) initialization procedure is as follows:
1. Turn ON the power.
2. Press "Reset" button when Status LED starts blinking rapidly.
3. Release "Reset" button when Status LED blinks slowly.
2010/2-1 D
Figure 8. Ejecting a blade
Convert the Hexadecimal number to Decimal number
12