Install The Car Audio System - Philips CE233 User Manual

s
•
Press repeatedly to select a
preset sound equalizer.
•
Press and hold to activate the
setup of bass, treble, balance,
and fader.
t /
• Tune to a radio station.
•
Press to skip to the previous/
next track.
•
Press and hold to rewind a track
or search fast forward.
u BAND
•
Press repeatedly to select a
tuner band.
v MENU
•
Press to access the system
menu.
w
•
Insert an SD/SDHC card.
x RESET
• Press to reset the system to
factory default settings.
EN
6
3 Install the car
audio system
Caution
•
Use the controls only as stated in this user
manual.
Always follow the instructions in this
chapter in sequence.
These instructions are for a typical
installation. However, if your car has
different requirements, make the
adjustment accordingly. If you have
any question regarding installation kits,
consult your local retailer.
Note
•
This system is designed for negative
ground (earth) 12V DC operation only.
•
Always install this system in the car
dashboard. Other locations can be
dangerous as the rear of the system heats
up during use.
•
To avoid short-circuit: before you connect,
make sure that the ignition is off.
•
Make sure that you connect the yellow and
red power supply leads after all other leads
are connected.
•
Make sure that all loose leads are insulated
with electrical tape.
•
Make sure that the leads do not get caught
under screws iron parts that will move (e.g.
seat rail).
•
Make sure that all ground (earth) leads are
run to a common ground (earth) point.
•
Use only the supplied mounting hardware
for a safe and secure installation.
•
Improper fuses can cause damage or fire.
When you need to change the fuse, consult
a professional.
•
When you connect other devices to this
system, make sure that the rating of the car
circuit is higher than the total fuse value of
all the connected devices.
•
Never connect speaker wires to the metal
body or chassis of the car.
•
Never connect speaker wires with stripes to
one another.