ZERO-X ZX-BTZ User Manual
  1. Manuals
  2. Brands
  3. ZERO-X Manuals
  4. Drones
  5. ZX-BTZ
  6. User manual

ZERO-X ZX-BTZ User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

• • • BLI T Z • • •
DRONE USER MANUAL
PRODUCT CODE: ZX-BTZ
www.zero-x.com.au • www.zero-x.co.nz
v1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZX-BTZ and is the answer not in the manual?

Questions and answers

Related Manuals for ZERO-X ZX-BTZ

Summary of Contents for ZERO-X ZX-BTZ

  • Page 1 • • • BLI T Z • • • DRONE USER MANUAL PRODUCT CODE: ZX-BTZ www.zero-x.com.au • www.zero-x.co.nz...

  • Page 3: Table Of Contents

    Welcome ......................4 Before you get up in the air ................. 4 General Safety ....................4 Battery Safety ..................... 5 Introduction ....................6 2.1 Package Contents ..................6 Fig 2.1.1 ....................6 2.2 Product Overview ..................7 Blitz Drone ....................7 Fig 2.2.1 ....................

  • Page 4: Welcome

    WELCOME Thanks for purchasing a Zero-X Blitz Drone, get ready to have the time of your life! We’re sure your Zero-X Blitz drone will bring you a world of great experiences in the air. Please take the time to read the following safety warnings and operating instructions carefully.

  • Page 5: Battery Safety

    BATTERY SAFETY When handled incorrectly, Lithium polymer batteries can be dangerous and can potentially harm and do damage to persons or property. Zero-X does not accept any liability of damage to persons or property if the battery is not correctly charged, stored or protected.

  • Page 6: Introduction

    INTORDUCTION 2.1 PACKAGE CONTENTS *Fig 2.1.1 1. 1 X Blitz Drone 2. 2 X Drone Batteries 3. 1 X Remote Control 4. 1 X Balance Charger with cables 5. 8 X Rotor Blades 6. Maintenance Kit 7. User Manual 8. 2 x Thumbstick covers...

  • Page 7: Product Overview

    PRODUCT OVERVIEW BLITZ DRONE 1. Top Shell Cover 2. Battery 3. Micro SD Card Slot* 4. Rear Rotor Blades 5. Motor 6. Front Rotor Blades 7. Camera 8. Front LED Lights Rear LED Lights 10. LED Status Light 11. Power Switch 1.

  • Page 8: Fig 2.2.1

    REMOTE CONTROL 1. Mode Setting Switch 2. Right Thumb Stick (Pitch/Roll) 3. Neck Strap Hook (Neck Strap not included) 4. Power Indicator LED 5. Power Switch 6. Speaker 7. Handle 8. Left Thumb Stick (Yaw) 9. Photo Capture 10. 5.8Ghz FPV Channel Switch 11.

  • Page 9: Fig 2.2.2

    SETTING UP YOUR BLITZ DRONE 3.1 CHARGING THE BATTERY Fully unwind the Charging Cable and the Power cord and connect the Charging Cable to the 4 pin connection on the Lithium polymer Balance Charger (left port). Connect the power cord to the balance charger and then plug into a power socket.

  • Page 10: Fig 3.2.1

    3.3 INSTALLING A MICRO SD CARD • Remove the top shell cover of the Blitz drone by lifting the top shell cover off from the section marked “Open”. • Insert the Micro SD Card (Micro SD Card not included) into the Micro SD card slot with the text facing the back of the drone.
  • Page 11 2. Once on, the LED lights on the arms of the Blitz drone should flash signalling no connection to the Remote Control. Place the Blitz drone on flat ground facing away from you and move back three metres. 3. With the left thumbstick in the lowest position, slide the left thumbstick to the bottom right position and hold for 3 seconds until the LED indicator on...

  • Page 12: Fig 4.1.1

    4.2 CONTROLLING YOUR BLITZ DRONE BASIC CONTROLS Lift / Descent Push up the Throttle Rudder Stick and the drone will fly up. Push down the Throttle Rudder Stick and the drone will fly down. Yaw Left / Right Push the Left Rudder Stick to the left or to the right, the drone will rotate in the corresponding direction.

  • Page 13: High Speed

    HIGH SPEED MODE: To activate high speed mode switch the Mode Setting Switch to the middle position marked advanced mode. (Refer to Fig 2.2.2 on page 8 - In this mode the sensitivity number 1). *Fig 4.3.2 of both the acceleration, and directional control of the Blitz drone will be increased, making the Blitz drone more nimble and quick.

  • Page 14: Maintenance

    MAINTENANCE CLEANING: Avoid exposing your Blitz drone and it’s accessories to dust, sand and moisture as these can damage the Blitz drone. If the Blitz drone is exposed to dust or sand, use a soft brush to remove any visible particles. ROTOR BLADE INSTALLATION AND REPLACEMENT GUIDE: To install or replace Rotor Blades on the Blitz please follow the Rotor Blade replacement instructions below.

  • Page 15: Specifications

    The retailer will then return the goods to Zero-X. Zero-X will repair, replace or refurbish the product at its discretion. The retailer will contact you when the product is ready for collection.
  • Page 16 www.zero-x.co.nz...

This manual is also suitable for:

Blitz

Table of Contents