Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Wan Access

Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access
Context
The PPP link does not strictly require that the peer route and local route exist at the same network
segment. Two ends of the PPP link at different network segments can communicate. In addition,
the peer host route at a different network segment is automatically added to local routing table
of direct routes.
However, when one end is configured with an incorrect IP address, the other end automatically
adds the incorrect peer host route to the local routing table of direct routes. As a result, the
incorrect routing information is advertised across the network.
With this command, you can decide whether the peer host route is added to the local routing
table of direct routes.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ppp peer hostroute-suppress
The peer host route is prevented from being added to the local routing table of direct routes.
Step 4 Choose one of the following methods to restart the interface.
l Run the shutdown and undo shutdown commands.
l Run the restart command.
----End

2.3.6 Checking the Configuration

After configuring the PPP protocol as the encapsulation protocol and setting the PPP parameters,
check whether the configurations are correct.
Prerequisite
All the configurations of PPP are complete.
Procedure
l
----End
Issue 02 (2011-07-15)
NOTE
After enabling or disabling the function of preventing the peer host route from being added to the local
routing table of direct routes, restart the interface to validate the configuration.
Run the display interface [ interface-type [ interface-number ] ] command to check the
PPP configurations on the interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 PPP Configuration
20