Huawei Quidway S9300 Configuration Manual - Wan Access page 21

Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure Switch A.
# Configure POS 1/0/0, set HDLC as the link layer protocol, and set default values for all physical
parameters.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] interface pos 1/0/0
[SwitchA-Pos1/0/0] link-protocol hdlc
[SwitchA-Pos1/0/0] ip address 10.1.1.1 30
[SwitchA-Pos1/0/0] quit
Step 2 Configure Switch B.
# Configure POS 1/0/0, set the clock mode to slave, and set default values for other physical
parameters.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] interface pos 1/0/0
[SwitchB-Pos1/0/0] clock slave
[SwitchB-Pos1/0/0] link-protocol hdlc
[SwitchB-Pos1/0/0] ip address 10.1.1.2 30
[SwitchB-Pos1/0/0] quit
Step 3 Verify the configuration.
Run the display interface pos command to check the connectivity of the POS interface on
Switch A.
<SwitchA> display interface pos 1/0/0
Pos1/0/0 current state : UP
Line protocol current state : UP
Last line protocol up time : 2011-01-11 16:58:21
Description:HUAWEI, Quidway Series, Pos1/0/0 Interface
Route Port,The Maximum Transmit Unit is 4470, Hold timer is 10(sec)
Internet Address is 10.1.1.1/30
Link layer protocol is nonstandard HDLC
Physical layer is Packet Over SDH
Clock: Master, Scramble, Loopback: none, CRC: 32
Threshold: SD 10e-6, SF 10e-3
Flag: J0 "NetEngine
Flag: J1 "NetEngine
Flag: C2 0x16
SDH error:
Issue 02 (2011-07-15)
Configure HDLC as the link layer protocol.
Configure IP addresses.
IP address of POS 1/0/0 on Switch A
IP address of POS 1/0/0 on Switch B
section layer: B1 0
line layer: B2 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
"
"
1 POS Interface Configuration
14