Huawei Quidway S9300 Configuration Manual - Wan Access page 51
Terabit routing switch
Hide thumbs
Also See for Quidway S9300:
- Configuration manual - network management (630 pages) ,
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access
Procedure
l
l
Issue 02 (2011-07-15)
In the IP-Trunk Interface View
Do as follows on the switchs that need to be configured with an IP-Trunk interface:
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface ip-trunk trunk-id
An IP-Trunk is created.
3.
Run either of the following commands to add the member interfaces of the IP-Trunk.
– Run the trunkport interface-type { interface-number1 [ to interface-number2 ] }
&<1-8> command to add member interfaces in batches.
– Run the trunkport interfacetype interface-number command to add a member
interface.
When setting the member interface range, note that a maximum of 8 member interfaces
can be added or deleted for one time.
In the Member Interface View
Do as follows on the switchs that need to be configured with an IP-Trunk interface:
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface ip-trunk trunk-id
An IP-Trunk is created.
3.
Run:
quit
Return to the system view.
4.
Run:
interface pos interface-number
The view of the interface to be added to the IP-Trunk is displayed.
5.
Run:
link-protocol hdlc
The link-layer protocol of the interface is configured as High-level Data Link Control
(HDLC). The link layer protocol of an interface to be added to the IP-Trunk must be
HDLC.
6.
Run:
ip-trunk trunk-id
The interface is added to the IP-Trunk.
When configuring an IP-Trunk interface, note the following points:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HDLC and IP-Trunk Configuration
44
Advertisement
Table of Contents
