Huawei Quidway S9300 Configuration Manual - Wan Access page 44

Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access
[SwitchB-Pos1/0/0] ppp chap user rtb
# Configure the authentication in CHAP mode.
[SwitchB-Pos1/0/0] ppp authentication-mode chap
Step 3 Verify the configuration.
After the configuration is completed, running the display interface command on every
switch, you can see the LCP status is Opened.
[SwitchA] display interface pos 1/0/0
Pos1/0/0 current state : UP
Line protocol current state : UP
Last line protocol up time : 2011-01-11 17:35:02
Description:HUAWEI, Quidway Series, Pos1/0/0 Interface
Route Port,The Maximum Transmit Unit is 4470, Hold timer is 10(sec)
Internet Address is 10.110.0.1/24
Link layer protocol is PPP
LCP opened, IPCP opened
Physical layer is Packet Over SDH
Clock: Master, Scramble, Loopback: none, CRC: 32
Threshold: SD 10e-6, SF 10e-3
Flag: J0 "NetEngine
Flag: J1 "NetEngine
Flag: C2 0x16
SDH error:
Last 600 seconds input rate 72 bits/sec, 0 packets/sec
Last 600 seconds output rate 64 bits/sec, 0 packets/sec
Input peak rate 4380776 bits/sec,Record time: 2011-01-11 17:34:39
Output peak rate 1760 bits/sec,Record time: 2011-01-11 17:04:32
Input:
Input error: 185 shortpacket, 0 longpacket, 10618 CRC, 5 lostpacket
Output:
Output error: 0 lostpacket
----End
Configuration Files
l
l
Issue 02 (2011-07-15)
section layer: B1 0
line layer: B2 0
path layer: B3 0
11490 packets, 2495499 bytes
445 packets, 20044 bytes
Input bandwidth utilization
Output bandwidth utilization : 0.01%
Configuration file of Switch A
#
sysname SwitchA
#
interface Pos1/0/0
link-protocol ppp
ppp authentication-mode chap
ppp chap user rta
ip address 10.110.0.1 255.255.255.0
#
aaa
local-user rtb password simple hello
#
return
Configuration file of Switch B
#
sysname SwitchB
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
"
"
: 0.01%
2 PPP Configuration
37