Recovering Your Picture - Dish Network 20.1 User Manual

Recovering Your Picture

Use the RECOVER button to get back to watching
satellite programming if you accidentally change
channels or inputs on your TV, DVD, and/or VCR.
To use this feature, you must set up Auto-Tune for
your TV (see page 16) and for your DVD/VCR (see
page 18).
Note: RECOVER only works if the remote control
has been set up to control the TV and/or DVD/VCR,
if connected. If the RECOVER button is used, the TV
channel programmed for SAT Auto-Tune is also the
channel that is sent to the TV. RECOVER first tries to
tune your TV to channel 3, then channel 4, and then other
video inputs with each press of the RECOVER button.
You may need to press the RECOVER button up to 30
times to recover your satellite TV video. If SAT Auto-Tune
is not set-up, RECOVER only tries channels 3 and 4.
1
2
3
4
Press and hold RECOVER
until all Mode buttons light up.
If you see the System Info
screen, proceed to step 4.
Otherwise, continue to step 3.
Press RECOVER again and
wait until the Mode lights
stop flashing. If you see the
System Info screen, go to
step 4. If not, repeat this step
until you see the screen.
Press SELECT to resume
watching TV.
20