Programming Remote To Control Second Receiver In Aux Mode - Dish Network 20.1 User Manual

Programming Remote to Control
Second Receiver in AUX Mode
If you have another DISH Network receiver
installed, you can use this remote control in AUX
mode to operate your new receiver. AUX mode
uses only IR signals, so the line of sight to the
second receiver must be unobstructed. You can
program the remote control to operate any other
DISH Network receiver except where UHF is
used, such as TV2 on DISH Network receivers.
1
2
3
4
5
6
Turn on the second receiver
and open System Info
screen.
Write down the TV2 address
that is shown.
Press and hold AUX until all
Mode buttons light up, then
release the button. AUX
flashes.
Use the Number Pad on the
remote control to enter a 3,
followed by the address in
step 2.
Press POUND (#). AUX
flashes three times.
Press RECORD to verify
that the address in the
remote control now matches
the address for the receiver.
23