Disassembling, Cleaning And Assembling; Disassembling And Reassembling The Crafty Cooling Unit - Storz & Bickel GMBH Crafty Instructions For Use Manual

10. DISASSEMBLING, CLEANING AND ASSEMBLING

When the vapors are cooled, it is in-
evitable that a small fraction is con-
densed on the internal surfaces of the
Cooling Unit.
The component parts of the Cooling
Unit, including the Mouthpiece must
be thoroughly cleaned on a regular
basis to guarantee proper operation
and pure flavor.
Product Overview of the CRAFTY Cooling Unit
The Cooling Unit consists of:
Cap Lock
Mouthpiece
Mouthpiece Seal Ring
Cooling Unit Cap
Base Seal Ring
(small)
Cooling Unit Base
Upper Screen
(coarse mesh width)
Base Seal Ring
(large)
For hygienic reasons, it is also neces-
sary to clean these components when
the Vaporizer is to be used by a differ-
ent person.
The condensate can
sticky. The Cooling Unit can
be dismantled more easily
when it first warmed up.
22
10. DISASSEMBLING, CLEANING AND ASSEMBLING
10.1. Disassembling and Reassem-
bling the CRAFTY Cooling Unit
Turn the Cooling Unit with a 90° rota-
tion counterclockwise in order to re-
be move it from the Vaporizer.
Pull out the Mouthpiece from the Cool-
ing Unit Cap, rotate slightly back and
forth while doing this, and pull off the
Mouthpiece Seal Ring.
Pulling the Mouthpiece from the Cooling Unit
Cap
Open the Cap Lock by pulling it rear-
wards.
Opening the Cap Lock
Remove the Cap Lock from the cap by
pulling up at one side.
If the Cooling Unit must be im-
mersed into alcohol (ethanol)
the Cap Lock only has to be
removed from the Cooling Unit. Ex-
tended contact with alcohol can lead
to whitening of the Cap Lock Label or
disintegration of the glue.
Removal of the Cap Lock
Separate the Cooling Unit Cap from
the Cooling Unit Base by pulling off
the cap upwards.
23