Prepare For Installation - HPE Aruba 2930F Quick Setup Manual And Safety/Regulatory Information

Prepare for installation

1. Unpack and check included parts:
Switch
Console cable (5188–3836)
Accessory kits (installation hardware)
Part number
5189–6934
5300–0140
AC power adapter (5066–5559)
Power cord (See
Documentation kit (5200–1998)
NOTE:
plan to mount the switch on a wall or under a table, you will need to provide four 5/8–inch
number 12 wood screws.
2. Prepare for installation.
CAUTION:
(page 4)
3. Power-on and verify that the self-test completes normally. An Aruba 2930F 8G switch does
not contain a power on/off switch. It is turned on by connecting the power cord to the AC
power adapter and to a properly-grounded AC power source, then connecting the AC adapter
to the switch.
6 Aruba 2930F 8G Switch Quick Setup Guide and Safety/Regulatory Information
"Power cords" (page
Screws for mounting the switch on a wall or under a table are not included. If you
To avoid personal injury or product damage, review the
before beginning the installation.
Count Included items
2 Rack mount brackets (long)
nl nl
4 Large screws; bracket-to-rack
nl nl
8 Small screws; bracket-to-switch
2 Wall/under-table brackets
nl nl
8 Small screws; bracket-to-switch
nl nl
1 Cable tie
nl nl
4 Rubber foot pads
15).
"Installation precautions"