HPE Aruba 2930F Quick Setup Manual And Safety/Regulatory Information page 13

NOTE: To ensure proper operation of your switch, use only genuine HPE Aruba SFP/SFP+
transceivers supported by your switch. For more information on using transceivers, see
"SFP/SFP+ installation notes" (page
3. Connect network cables.
NOTE: In the factory default configuration, the switch automatically obtains its IP network
settings from a DHCP or BootP server after connecting to the network. If you do not use direct
console access to initially determine the switch IP address, you can determine the assigned IP
address by inspecting your DHCP/BootP server or by querying LLDP information from another,
directly connected neighbor switch. CLI LLDP commands for an ArubaOS neighbor switch are
listed below.
14).
Connecting the switch to the network 13