PC Connection
3
Install the USB driver
following onscreen
instructions
* Although an error message
appears, continue installation.
Tip
To uninstall the USB driver, select
・
830ca_un.exe on the Utility Software
CD-ROM.
Data Transfer
About Data Transfer Tools
Use this software to back up Phone Book,
Schedule and To Do List data on handset
to your PC and to restore the data to
handset after editing it on your PC.
For information about how to install
the software, see the manual on the
12
Utility Software CD-ROM.
12
-6
Setting USB Mode
Set USB mode before connecting
handset to your PC via USB cable.
To use Data Transfer Tools or to use
handset as a modem for packet
transmission, set USB mode to
Communication mode.
To manipulate memory card data from
a PC, set it to microSD mode.
1
d
Settings
d
External Connection
USB mode setting
2
Communication mode or
microSD mode
Manipulating Memory
Card Data from a PC
Connect handset to your PC using a
USB cable, and manipulate memory
card data from the PC.
Set USB mode setting to microSD
●
mode in advance.
1
Connect handset to your PC
using a USB cable
This enables memory card data to
be manipulated from your PC.
2
When you are finished,
disconnect handset from the
PC
Follow the procedure for safely
removing external devices (which
differs slightly according to the
operating system), when
d
disconnecting handset from the
d
PC.
Note
Make sure handset and the PC are properly
・
d
connected. Otherwise, data cannot be
transferred, and may even be lost.
If handset's battery is almost or
・
completely empty, data cannot be
transferred, and may even be lost.
Check handset's battery level and the
power of your PC.
Do not remove the USB cable while
・
copying data from your PC to handset.
If the USB cable is removed during data
transfer, data cannot be transferred,
and may even be lost.