Seiko CT-2000 Operating Manual page 35

③ Set the scheduled start time.
Press @@@ or @@@
Press @@@@ or @@@@
Press @@@ to register the time you have set.
④ Input a start signal.
Input a start signal from an external device, or press
pressed.
* Start signal can be input starting from 30 seconds before the scheduled start time.
If a start signal is input before that, [TEST] is printed out to indicate that the timer is
ready for the input of a start signal.
* By disabling [Countdown display], countdown of time before start will not be displayed
on the scoreboard.
For the setting procedure, refer to【4.3 Measurement Mode Setting】on P. 19.
⑤ The difference between the scheduled and actual
start times is calculated.
The difference between the time when the start
signal is input and the scheduled start time
("Diff.") is calculated and displayed.
* If the actual start time is earlier or later than the scheduled start time, "-" or "+" is
attached before the time difference, respectively.
⑥ Measure the time.
Input a CH signal from a grip switch, or press
@@@, @@@ or @@@
* Time measurement cannot be made before the start signal has been input.
⑦ Stop the timer.
Press @@@ while keeping
⑧ Reset the timer.
Press @@@ while keeping
When the timer is reset, the display returns to the one shown in Step ① above, and the
block No. is incremented by one.
to set the time digits.
to move the cursor.
Time before scheduled
start time
Scheduled start time
to measure the time.
@@@@ pressed to stop the timer.
@@@@ pressed to stop the timer.
- 31 -
Current time
@@@ while keeping @@@