Table of Contents
Advertisement
OPERATING INSTRUCTIONS
• Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is enough
to cause serve injury.
• Before attempting to use this cordless drill, become
familiar with all of its operating features and safety
requirements.
• To reduce the risk of serious personal injury, turn
tool off and disconnect battery pack before making
any adjustments or removing/installing attachments or
accessories.
CHARGING PROCEDURE
• Connect the plug cable to the charger, and then plug into an
appropriate outlet before inserting
battery pack. After approx 5 sec, all three
charging lights will be on for two seconds
and then off, indicating power is available
(fig. A)
at the charger.
• Insert the battery pack into the charger,
making sure the pack is fully seated in the
charger. The charging process has now
(fig. B)
begun.
During the charging process, the charging
lights will indicate the charging status as
below:
- Less than 30% charged, all three charging
lights will blink in sequence.
- Less than 60% charged, one light will
stay on, while the other two lights will
blink in sequence.
- Over 60% charged, two lights will stay on, while the remaining
light will blink continuously.
- Fully charged, all three lights will remain on continuously.
• As a guide, the charging process will be last approximate 30 min
for a 2 Ah Battery Pack and approx 60 min for a 4Ah battery pack,
and will be displayed by permanent lighting of all three charging
lights.
Touch_IM_ED8.indd 3
CHARGER DIAGNOSTICS
The charger is designed to detect certain problems
that can arise with battery packs.
• When the charger detects a battery pack that is overheated, all
three charging light will blink at the same time. Please remove the
battery and allow it to cool down for 15 – 30 minutes and re-insert.
• When the charger detects malfunction in the battery or the charger,
two charging lights will blink at the same time. Please remove
the battery and allow to cool down for 15-30 minutes. Then re-
insert the battery pack into the charger, if two charging lights still
flashes, the battery or charger may require service.
NOTE: Charging times maybe longer depending on the
surrounding temperature and battery conditions.
Fitting and removing the battery pack
to the drill
• To install the battery pack to the tool, align
the raised portion of the battery pack with
the grooves on the bottom of the drill, and
slide it firmly into the handle until you
hear the lock snap into place.
• To remove the battery pack from the tool,
A
press the battery pack release button and
slide the battery pack completely out of
tool handle.
Battery charging
CAUTION!
• Before attempting to charge the battery, check the
charger and the battery to ensure the charging equipment
matches the battery supplied. The components are all
B
labeled with component numbers.
• The rechargeable battery is not fully charged on leaving the
factory. Charge the rechargeable battery before first use.
• Recharge discharged batteries as soon as possible after
use or battery life may be greatly diminished. For longest
battery life, do not discharge batteries fully.
• The working temperature of the charger is 0 degree to
45 degrees (32 degree f to 115 degree f).
3
(fig. C)
C
22/10/13 4:39:52 PM
Advertisement
Table of Contents
