Table of Contents
Advertisement
3.7. Incoming Call Line Identification (CLI)
When a call is received the last six digits of the CLI information is matched with the phonebook. Therefore an incoming call
could be matched to the wrong phonebook entry.
3.8. Hot Key Dial Source List
The source for Hot Key Dial Numbers is normally 'Phonebook' or 'Service Dial Numbers'. For some OEMs it may be a
requirement to store these numbers in Flash-ROM. When the source is the Flash-ROM and the telephone software is
updated, the source numbers may be lost. Also, if the user changes the source of the Hot Key Dial numbers, it will not be
possible to redirect the source back to Flash-ROM. However, in the event that an OEM would like the Hot Key Dial source to
be stored in the Flash-ROM, it is unlikely that the user will have the option to change the Hot Key Dial source.
3.9. Public Man Machine Interface (MMI)
3.9.1
General
It is possible to operate all GSM telephones in the same way using the Public MMI. The following operations will work with all
GSM telephones. However, this information is restricted to those operations supported by the telephone.
The * and # in the following procedures should be replaced by
-
,
replaced with
and
3.9.2
Reading the Phonebook Memory Location
# <MEMORY LOCATION>
Leading zeros can be left out of the location number, e.g. 007 can be 7.
3.9.3
Presentation of IMEI
* # 0 6 #
3.9.4
Security
Change PIN
Change PIN2
Unblock PIN
Unblock PIN2
3.9.5
Call Hold
Place a Call on Hold
Recall a Held Call
Make a Second Call
Swap between two Held Calls
End Held Call
End Active Call
Reject Incoming Call
3.9.6
Call Waiting
Enable Call Waiting
Disable Call Waiting
Call Waiting Status
MCUK011201C8
Service Manual
keys.
* * 0 4 * <OLD PIN> * <NEW PIN> * <NEW PIN> #
* * 0 4 2 * <OLD PIN2> * <NEW PIN2> * <NEW PIN2> #
* * 0 5 * <PIN UNBLOCKING KEY> * <NEW PIN> * <NEW PIN> #
* * 0 5 * <PIN2 UNBLOCKING KEY> * <NEW PIN2> * <NEW PIN2> #
2 <SND>
2 <SND>
<TELEPHONE NUMBER> <SND>
2 <SND>
0 <SND>
1 <SND>
0 <SND>
* 4 3 * <SND>
# 4 3 * <SND>
* # 4 3 * # <SND>
and
respectively. Also <SND> and <END> should be
Section 3
– 7 –
OPERATING INSTRUCTIONS
Revision 0
Issue B
Advertisement
Table of Contents
