1. Using a small screwdriver blade or similar blunt object, depress one of the RF Shield lugs (marked 'A' and 'B' in the
diagram below) to release the PCB from the case.
4.2.2
LCD Removal
1.
Gently prise apart the two ears of the metal snap (marked 'A' and 'B' in the diagram below) so that it is released from the
PCB.
2.
The LCD module and metal snap can now be removed from the PCB. Separate the metal snap from the LCD module by
gently prise either of the two smaller ears (marked 'C' and 'D' in the diagram below) until it clears the LCD holder.
MCUK011201C8
Service Manual
Figure 4.4: PCB Assembly Removal
A
1 0 5 0 7 - 1
Figure 4.5: LCD Module Removal
C
10537-1
Figure 4.6: Removing the Metal snap
Section 4
– 21 –
DISASSEMBLY / REASSEMBLY INSTRUCTIONS
10507-1
B
D
Issue B
Revision 0