Table of Contents
Advertisement
3.11. Important Error Messages
The following table is a list of error messages that may occur during use of the telephone, with a description and suggested
course of action:
Error Message
Area not Allowed
Roaming in the selected area is not allowed.
Network not Allowed
Roaming with the selected network is not allowed.
Security Failure
The network has detected authentication failure because the SIM is not registered with that network. Contact
the Service Provider.
SIM Blocked
The SIM is blocked because the wrong PUK has been entered ten times. Contact the Service Provider.
SIM Error
The telephone has detected a problem with the SIM. Switch the telephone off and then back on. If the
message does not disappear, contact the Service Provider.
Message Rejected
A message has been received but the message store is full. To receive messages, delete some of the currently
stored messages or set messages to automatically clear (Menu: Messages: Parameters: Auto Delete).
Store Full
PIN2 Invalidated
The PIN2 is blocked permanently because the wrong PUK2 has been entered 10 times. Services controlled by
PIN2 cannot be used. Contact the Service Provider.
Warning Store Full
The message area is full. New messages cannot be stored until some of the currently stored messages are
deleted.
Continue?
Auto Redial List Full
Redial list of unsuccessfully dialled numbers is full. Switch the telephone off and then on again.
3.12. Security Codes
Code Type
Personal
4 to 8
Identification Number
(PIN)
PIN 2
4 to 8
PIN/PIN 2 Unblocking
Key
(PUK/PUK 2)
8
Supplied by the
service provider.
Password
4
Lock Code
4
Factory set to "0000".
MCUK011201C8
Service Manual
Number of Digits
Explanation / Remedy
Controls SIM security. Supplied by the service provider.
Controls memory security. Supplied by the service provider.
Used to unblock PIN and PIN 2. A PIN or PIN 2 will become blocked if the
wrong PIN or PIN 2 is entered three times. When the blocked PIN or PIN 2
is unblocked, a new PIN or PIN 2 must be entered. If the wrong PUK or
PUK 2 is entered 10 times, the cursor SIM will be unusable.
Controls the call bar function. If the wrong password is entered three
times, this service will be revoked. Supplied by the service provider.
Controls telephone security.
Section 3
– 11 –
OPERATING INSTRUCTIONS
Description
Issue B
Revision 0
Advertisement
Table of Contents
