Docomo STYLE Series P-03A Instruction Manual page 64

Delete all Enter your Terminal Security Code YES
Information
<Delete this> <Delete all>
You cannot delete the country/area code or international call access code set by
"Auto assist setting".
<Prefix Setting>
Storing Numbers to be Added to the
Beginning of a Phone Number
You can store prefix numbers such as international call access codes or
"186"/"184" and add them to the phone number for dialing. You can store
up to seven prefix numbers.
m Set./Service Network setting Prefix setting
1
Highlight <Not recorded> and press l(
If you select a stored prefix, you can check the stored contents.
To delete a stored prefix, press i(
all" then select "YES". If you select "Delete all", you need to enter your Terminal
Security Code.
2
Enter a name Enter a prefix number.
You can enter a name of up to 8 full-pitch/16 half-pitch characters.
You can enter a prefix number of up to 16 digits. The keys for entry are limited to
0 through 9, s and a.
Prefix Numbers
You can add a prefix number to the beginning of phone number when
you make a call.
1
Enter a phone number
or
call up the detailed display of a Phonebook entry, redial
item, dialed call record, or received call record.
62
).
) and select "Delete this" or "Delete
i(
2
) Prefix numbers Select a name
d or O o (
)
Press l(
) to make a videophone call.
<Sub-address Setting>
Making a Call Specifying a Sub-address
You can set whether to regard the numbers after ":" of a phone number
as a sub-address to access the specified phones or data terminals.
The sub-address is a number assigned to identify each ISDN terminal connected to an
ISDN line. It is also used for selecting contents on "V-live".
m Set./Service Other settings
1
Sub-address setting ON or OFF
Information
Even if you set "Sub-address setting" to "ON", ":" at the top of phone numbers and
":" immediately after the prefix number or "186"/"184" are not regarded as
sub-address mark-off symbols.
<Reconnect Signal>
Setting Alarm for Reconnecting
You can set an alarm that sounds until a voice call or videophone call is
reconnected after disconnected owing to bad radio wave conditions.
m Set./Service Talk Reconnect signal
1
Select an alarm.
Information
The reconnectable time differs depending on the usage status and radio wave conditions.
An estimate is about 10 seconds and the call charge is applied also for that duration.
While you are disconnected, no sound is transmitted to the other party.
m + 7 - 7 -