Teltonika RUT230 User Manual page 85

Field name
1. Enable
2. IKE version
3. Mode
4. My identifier type
5. My identifier
6. Dead Peer
Detection
7. Pre shared key
8. Remote VPN
endpoint
9. IP address/Subnet
mask
10. Enable keep alive
11. Host
12. Ping period (sec)
Phase 1 and Phase 2 must be configured accordingly to the IPSec server configuration, thus algorithms,
authentication and lifetimes of each phase must be identical.
Value Explanation
Enabled/Disabled Check box to enable IPSec.
IKEv1 or IKEv2 Method of key exchange
"Main" or ISAKMP (Internet Security Association and Key Management Protocol)
"Aggressive" phase 1 exchange mode
Address, FQDN, Choose one accordingly to your IPSec configuration
User FQDN
Set the device identifier for IPSec tunnel.
In case RUT has Private IP, its identifier should be its own LAN network
address. In this way, the Road Warrior approach is possible.
Enabled/Disabled The values clear, hold and restart all active DPD
A shared password to authenticate between the peer
Domain name or IP address. Leave empty or any
Remote network secure group IP address and mask used to determine to
what subnet an IP address belongs to. Range [0-32]. IP should differ from
device LAN IP
Enabled/Disabled Enable tunnel keep alive function
A host address to which ICMP (Internet Control Message Protocol) echo
requests will be send
Send ICMP echo request every x seconds. Range [0-999999]
85