Electrolux UltraSteam ESI6123 Manual page 5

Getting started / 使用说明
1. Before first use. Remove all
adhesive remains and gently rub
with a dampened cloth. Rinse
water tank to remove foreign
particles. When turned on for the
first time, temporary vapours/
odours may occur.
1. 首次使用前，请先清理掉所有粘附
残 留 物 ， 并 用 一 片 湿 布 轻 轻 地 擦
拭。冲洗水槽，以清理掉所有异物
颗粒。首次开机时，熨斗可能会在
短时间内发出气味/异味。
2. Filling steam iron with water.
Make sure plug is removed from
power outlet. Turn the temperature
selector to '0' and open water
fill cover. Let the iron rest on the
heel. Using beaker provided, pour
water up to maximum level. Close
cover. Caution: Do not exceed
the maximum water level. This
product is appropriate for use with
tap water. It is recommended to
use distilled water or a mix of 50%
distilled, 50% tap water. Never
use distilled water only. Never put
scented water, vinegar or ironing
aids in the water tank. This may
cause brown spitting and staining.
2. 向蒸汽熨斗内注水。确保熨斗的电源
插头已经从电源插座上拔掉。将温
度旋钮调至"0"，然后打开注水孔
盖。将熨斗立放在熨斗架上。向随附
的广口杯内注水至最高水位。盖上盖
板。注意：请勿超出最高水位。本产
品适合使用自来水。建议使用蒸馏水
或混合使用50%的蒸馏水和50%的自
来水。请勿仅使用蒸馏水。 请勿向
水槽内注入香水、醋或烫衣剂。这会
造成衣物脱色和染色。
3. Plug power cable into a power
outlet. Power indicator light turns
on, red colour. Set temperature by
turning temperature selector to
adequate choice. When the light
turns green, the iron is ready to use.
The light will switch between
red and green as the iron
is maintaining the selected
temperature. The hot soleplate
indicator turns red when the iron
reaches 40°C.
3. 将插头插入电源插座。电源指示灯随
即点亮，发出红光。通过旋转温度旋
钮设置合适的温度。当温度指示灯变
为绿色时，即表示熨斗已准备就绪。
该指示灯会在红绿之间切换，从而
保持您所选定的温度。当熨斗温度达
°C
到40 时，底板高温指示灯会变亮。
EN
CNS
5