Authentication Config - TP-Link AC50 Configuration Manual

Status
Note:
1. The empty strategy means all sources are allowed to visit.
2. Only when one of the source port or the destination port is configured, can the protocol take effect.

7.2.7 Authentication Config

Choose the menu Authentication > Portal Authentication > Authentication Config to load
the following page.
Figure 7-21 Authentication Config
Here you can configure and view the global parameters for the authentication.
Authentication Aging
Aging Time
Portal Authentication
Port
Specify whether to turn on the free authentication policy.
Specify whether to enbale authentication aging. If the authenticated users
leave the wireless network within the aging time, they could reconnect to the
AP without re-authentication. If the leave time is longer than the aging time,
authentication is required again for users to connect to the AP.
Enter the aging time within which the users could reconnect to the AP without
authentication.The default value is 5.
Specify the service port for portal authenticaiton. The default setting is 8080. It
should not be the same as other occupied service ports.
56