Table of Contents
Advertisement
Choose the menu AP Control > Load Balancing > Load Balancing to load the following
page.
Figure 4-8 Load Balancing
Load Balancing
Mode
Threshold
Difference Threshod
Maximum Fail Number
RSSI Threshold
Specify whether to enable load balancing.
Load balancing supports session mode only at present. In this mode, each AP
will be assigned an average number of clients by the AC.
Set the maximum number of clients that are allowed to access the AP. The
client's request to connect to the CAP will be rejected when the threshold and
difference threshold are exceeded.
Set the maximum difference between the number of clients connected to the
AP with the number of clients connected to other APs. The client's requests
to connect will be rejected when the threshold and difference threshold are
exceeded.
Set the maximum fail number for the client's connection request. When the
client's connection requests fail more than the specified number, the AP will
allow it to connect.
Specify the RSSI (Received Signal Strength Indicator) threshold. If the signal
strength of the client is lower than the RSSI threshold, it will not count to the
total number of clients for the purpose of load balancing.
29
Hide quick links:
Advertisement
Table of Contents
