Samsung AS12SGGE Training Manual page 30

Installation Diagram of Indoor Unit and Outdoor Unit
5-2-3. Connecting the Assembly Cable (Cooling Oly)
The outdoor unit is powered from the indoor unit via the assembly cable. (7K/9K/12K)
1. Extend the assembly cable if necessary.
2. Open the front grille by pulling on the tab on the lower right and left sides of the
indoor unit.
3. Remove the screw securing the connector cover.
4. Pass the assembly cable through the rear of the indoor unit and connect the assembly
cable to terminals.
Each wire is labelled with the corresponding terminal number.
5. Firmly fix the ass'y cable with clamp wire holder.
6. Pass the other end of the cable through the 65mm hole in the wall.
7. Replace the connector cover, carefully tightening the screw.
8. Close the front grille.
9. For further details on how to plug the other end of the assembly cable into the
outdoor unit.
5-2-4. Connecting the Assembly Cable (Heat Pump)
The outdoor unit is powered from the indoor unit via the assembly cable. (7K/9K/12K)
1. Extend the assembly cable if necessary.
2. Open the front grille by pulling on the tabs on the lower right and left sides of the
indoor unit.
3. Remove the screw securing the connector cover.
4. Pass the assembly cable through the rear of the indoor unit and connect the
assembly cable to terminals
Each wire is labelled with the corresponding terminal number.
5. Pass the other end of the cable through the 65 mm hole in the wall.
6. Replace the connector cover, carefully tightening the screw.
7. Close the front grille.
8. For further details on how to plug the other end of the assembly cable into the
outdoor unit.
INSTALLATION
(Cont.)
Indoor
N1 1
unit
E 1
N1 1 N
E 1
N1
Outdoor
N1 1 2 3
unit
Indoor
N1 1 2 3
unit
1
1 2 3 E
N1 N1
1 2 3 E
N1 N1
Outdoor
N1 1 2 3
unit
SAMSUNG | 29
5