Faqs - JK Audio AutoHybrid IP2 User Manual

FAQs

1. I am receiving
When both end-points do not share a preferred codec, the call might fail. If
there's a compatibility issue between the two end-points, error message: Not
Accepted Here will be displayed. This means that the two end-points could
not agree on a codec. To resolve this issue, make sure the two end-points
have a few codecs in common.
2. I changed my network settings and now I can not connect to
the AutoHybrid IP2.
Perform a Network Reset found on page 15 to reset your device to the
default Dyniamic IP setting. See page 5 to find the Dynamic IP address.
3. I have lost my power supply for my AutoHybrid IP2.
I have a power supply that fits from a different product. Can I
use this instead?
No! Never use a power supply other than the one that was supplied by your
manufacturer. Power supplies are available in either AC or DC output with
many combinations of voltage and available current. Most consumer power
supplies are not regulated. This could invariably damage your equipment, and
also create a great deal of noise. Our products are designed for and tested
with their respective power supplies for optimum operation. If you have lost
your power supply, please contact your JK Audio dealer or our Customer
Service department.
AutoHybrid can also run using PoE power, supplied over the ethernet cable
from a PoE equipped switch or router.
4. Will the USB port on the AutoHybrid IP2 act as a sound card
when connected to a computer?
No. The USB port is not designed to exchange audio between the
AutoHybrid IP2 and your computer.
14
AutoHybrid IP2™ VoIP/AoIP Codec
error message: NOT ACCEPTED HERE