JK Audio AutoHybrid IP2 User Manual page 16

Network / System
WAN Settings
Dynamic IP
AutoHybrid IP2 is assigned an IP address in the network.
Static IP
Obtain a static IP address from your internet service provider to have remote
access via the public internet or create a unique static IP address on your LAN.
PPPoE
Point to Point Protocol over Ethernet is used by some internet service providers
to provide an authentication mechanism for connecting to the internet. Most
of the parameters entered here should have been provided by your ISP.
Service Name can generally be left blank. Mode is the method of maintaining
a connection. On Demand mode will drop the connection to the internet after
there is no activity for Idle Time. It will reconnect when an outbound connection
is requested. The default Idle Time is 3 minutes. Keep Alive mode will send keep
alive messages every Redial Period to maintain the connection. The default
Keep Alive period is 1 minute.
VLAN Settings
Enable
The Enable checkbox enables the Virtual LAN (VLAN) tagging. If the network
does not support VLAN and the VLAN tagging is enabled on the IP2, the IP2 will
become unreachable on the network. Resetting the network configuration from
the front panel will disable the VLAN tagging and reset the VLAN configuration to
default settings.
VLAN ID
VLAN ID is the VLAN identifier which indicates which VLAN the device is in.
VLAN Priority
VLAN Priority specifies the Priority Code Point (PCP) field in VLAN header. The
priorities are as defined in the 802.1p Class of Service (CoS) standard..
Identification
Friendly Name
Change the Friendly Name used to identify your AutoHybrid IP2.
User Name
Change the login username and password.
12
AutoHybrid IP2™ VoIP/AoIP Codec