Assembly Instructions Accessories - Etac Sting Manual

Assembly instructions are always
provided with accessories when they
are delivered from Etac.
10:1 Height adjustable push handles
The push handles can be set at inter-
vals of 5 cm.
Remove the backrest upholstery, fix
the smaller of the fixing lugs to the
back tubes. Mount the upper push
handle attachment onto the back
tubes and replace the upholstery. Fix
the attachment tube for the vertically
adjustable push handles into the upper
attachments. Mount the larger fixing
lugs onto the tubes. Secure by means
of the screws and nuts. Fix together
the two attachment tubes in the mid-
dle. Tighten all screws. Loosen the
knobs on the attachment tubes and
install the required height for the push
handles. Tighten the knobs.
10:2 Anti-tip
The anti-tip consists of four parts:
- The attachment bar is mounted
under the wheel mount (see
illus).
- The anti-tip bar snaps onto the
attachment bar at the required
length.
- The extension with the stabilis-
er wheel is fixed to the anti-tip
bar by means of a screw and
nut at the desired height.
To allow you to negotiate thresh-
olds and the edges of thick carpets,
a distance of 3-4 cm from floor level
is recommended. A special anti-tip
with a shorter anti-tip bar is available
for Sting with 20" wheels mounted in
position C.
10 Assembly instructions: accessories
Instructions are also available on our website
www.etac.com
Tools: 4 mm, 5 mm, 6 mm
Allen key and 10 mm spanner
Ensure that the knobs are
properly tightened. This is es-
pecially important if you intend
to lift the wheelchair whilst the
user is sitting in it.
Tools: 4 mm Allen key, 8 mm
spanner. 2 x 5 mm Allen keys
for affixing to chassis.
(!) The extended extra anti-tip
bar is recommended when the
rear wheels are mounted in
position A.
After adjusting the seat height,
centre of balance or backrest
angle, the function of the anti-
tip should always be checked.
23