Table of Contents
Advertisement
6:7 Height adjustment of the rear wheels
Unscrew the axle sleeves and washers,
tilt the rear axle to free it and mount it
at the required height. Mount the rear
axle with the large bevelling towards
the right wheel attachment. At the
same time as the rear seat height is be-
ing adjusted you should make sure you
have set the correct centre of balance.
See point 9:8.
Tools: 21 mm socket spanner.
6:8 Adjusting the brakes
The brakes are variably settable along
the lower frame tube.
-
Loosen the screws a couple of
turns and slide the brake so
that the brake block is about
20 mm from the tyre when the
brake is not applied.
-
Test the brakes.
Tools: 5 mm Allen key
6 Settings seat
Check that the rear wheels are
correctly mounted, see point
6:6. Always check the position
of the anti-tips.
Always adjust the brakes after
re-positioning the rear wheels.
(!) Also adjust the angle of the
front fork attachment.
The braking effect is depend-
ent on the air pressure in the
tyres.
The brakes are parking brakes
and should not be applied dur-
ing use.
12
Brake lever extensions are
available as accessories, see
point 10:16.
Advertisement
Table of Contents
