Removing And Replacing A Power Supply - HPE EDGELINE EL10 Maintenance And Service Manual

WAN
WLAN
4. Unscrew and remove the antenna from the gateway.
To replace the component, reverse the removal procedure.
You must press the Power On/Off button twice to power on the system.

Removing and replacing a power supply

Procedure
1. Power down the gateway.
2. Disconnect the power cord from the power connector at the rear of the gateway.
To replace the component, reverse the removal procedure.
You must press the Power On/Off button twice to power on the system.
WAN
WLAN
Removing and replacing a power supply 25