Removing And Replacing A Drive - HPE EDGELINE EL10 Maintenance And Service Manual

Removing and replacing a drive

Procedure
1. Power down the gateway.
2. Dismount the gateway.
CAUTION:
DO NOT remove the top access panel under any circumstance. Removing the top access panel
can harm the heatsink or void the warranty to the equipment.
3. Remove the bottom access panel.
4. Disconnect the signal and power jumper cables to the drive.
5. Using a T-10 Torx screwdriver, remove the four screws securing the drive to the access panel.
6. Remove the drive.
Removing and replacing a drive 21