HP ProLiant DL80 Gen9 Maintenance And Service Manual page 51

IMPORTANT: Processor socket 1 must be populated at all times or the server does not
function.
To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
Remove the air baffle
5.
Remove the heatsink.
6.
Open each of the processor locking levers in the order indicated, and then open the processor
7.
retaining bracket.
CAUTION: THE PINS ON THE SYSTEM BOARD ARE VERY FRAGILE AND EASILY
DAMAGED. To avoid damage to the system board, do not touch the processor or the
processor socket contacts.
("Access panel" on page 35).
("Air baffle" on page 36).
Removal and replacement procedures 51