Page 1
ST 1800A18 English Français Español Português...
Page 6
ST 1800A18 Original operating instructions ........Mode d'emploi original .
Page 7
• Make a note of the designation and serial number printed on the identification plate in the following table. ▶ Always quote this information when you contact a Hilti representative or Hilti Service to make en enquiry:...
Page 8
Product information Cordless metal screwdriver ST 1800A18 Generation Serial no. 2 Safety 2.1 Safety instructions The safety rules given in the following section contain all general safety rules for electric tools which, in accordance with the applicable standards, require to be listed in the operating instructions. Accordingly, some of the rules listed may not be relevant to this electric tool.
Page 9
▶ Do not lift or carry the tool by the accessories attached to it. ▶ To reduce the risk of injury, use only genuine Hilti accessories and accessory tools. ▶ Observe the national health and safety requirements.
Page 10
Metal construction screwdriver, STDG 19 depth gauge, STDC protective cap, SNSD 8 screwdriving bit, operating instructions. Note Spare parts, consumables and accessories approved by Hilti for use with the product can be found at your local Hilti Center or online at: www.hilti.com...
3.4 Liion battery display The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on the Liion battery. The charge status of the Liion battery is displayed after pressing one of the two battery release buttons.
Page 12
After fitting the drill bit, grip it and pull it in order to check that it is securely engaged. Fitting / removing the screw guide (optional) Note Use of the ‚Hilti‘ ST-SG 5.5/6.5 screw guide is recommended for sandwich panel screws. Setting forward or reverse rotation Note An interlock prevents switching while the motor is running.
Page 13
Removing screws Note Remove the depth gauge or screw guide, if fitted. Set the forward / reverse switch to the “Reverse” position. Removing the battery 6 Care of the metal construction screwdriver WARNING Electrical hazards! Improper repairs to electrical parts may lead to serious injuries. ▶...
Page 14
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, your old tools, machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
Page 15
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, your old tools, machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.