Power Configuration - Supermicro X11SAE-M User Manual

Chapter 4: BIOS
Wait For 'F1' If Error
Use this feature to force the system to wait until the 'F1' key is pressed if an error occurs.
The options are Disabled and Enabled.
INT19 (Interrupt 19) Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this item is
set to Immediate, the ROM BIOS of the host adaptors will "capture" Interrupt 19 at bootup
immediately and allow the drives that are attached to these host adaptors to function as
bootable disks. If this item is set to Postponed, the ROM BIOS of the host adaptors will not
capture Interrupt 19 immediately and allow the drives attached to these adaptors to function
as bootable devices at bootup. The options are Immediate and Postponed.
Re-try Boot
If this item is enabled, the BIOS will automatically reboot the system from a specified boot
device after its initial boot failure. The options are Disabled, Legacy Boot, and EFI Boot.
Install Windows 7 USB support
When this item is set to enabled, the keyboard and mouse plugged into the USB 3.0 ports
are accessible during the Windows 7 installation. After the Windows 7 and XHCI driver
installations, set this item to Disabled. The options are Disabled and Enabled.

Power Configuration


DeepSx Power Policies
Use this item to configure the Advanced Configuration and Power Interface (ACPI) settings for
the system. Enable S3 to use Standby Mode (Suspend-to-RAM) and maintain power supply
to the system RAM when the system is in the sleep mode. Enable S4 to use Hibernation
mode (Suspend to Disk) so that all data stored in of the main memory can be saved in a non-
volatile memory area such as in a hard drive and then power down the system. Enable S5 to
power off the whole system except the power supply unit (PSU) and keep the power button
"alive" so that the user can "wake-up" the system by using an USB keyboard or mouse. The
options are Disabled and Enabled
Watch Dog Function
If enabled, the Watch Dog Timer will allow the system to reset or generate NMI based on
jumper settings when it is expired for more than 5 minutes. The options are Disabled and
Enabled.
Power Button Function
This feature controls how the system shuts down when the power button is pressed. Select
4_Seconds_Override for the user to power off the system after pressing and holding the power
button for 4 seconds or longer. Select Instant Off to instantly power off the system as soon
as the user presses the power button. The options are Instant Off and 4 Seconds Override.
67