TE Connectivity 59275 Instruction Sheet page 4

Figure 3
Figure 4
Rev M
4.2. .Spare Wire Caps
1. Strip wire to dimensions listed in Figure 2. Crimp
the color coded portion of the tool. Refer to 
Section 3.
Do not use wire with nicked or missing conductor
NOTE
strands.
i
2. Place tool insulation adjustment indicator in
Position 4.
3. Close tool handles until crimping jaws partially
close, but leave enough space for cap to be
inserted between dies.
4. Raise locator so that end of cap rests against the
recessed surface of the locator as shown in 
Figure 5.
Spare Wire Caps
Wire
Barrel
Locator
Raise Locator So the End
of the Cap Rests Against
the Recessed Surface of
the Locator
Figure 5
5. Squeeze quick take-up trigger and close handles
until cap is held firmly in place. Do not deform cap
wire barrel.
6. Insert stripped wire into cap until conductor
bottoms in cap.
7. Hold wire in position and complete crimp by
closing handles until the ratchet releases. Handles
will open automatically and crimped cap may be
removed.
8. Refer to Section 6 and Figure 7 wire cap crimp
inspection procedure.
408-1610
Insulation
Adjustment
Indicator at
Position 4
4 of 11