TE Connectivity 59275 Instruction Sheet page 11

3. Check the clearance between the bottoming
surfaces of the crimping dies. If the clearance is
.025 mm [.001 in.] or less, the ratchet is satisfactory.
If clearance exceeds .025 mm [.001 in.], the ratchet
is out of adjustment, and must be repaired. Refer to
Section 8, REPLACEMENT AND REPAIR. If the
tool conforms to these inspection procedures,
lubricate it with a THIN coat of any good SAE‡ 20
motor oil and return it to service.
8. REPLACEMENT AND REPAIR
Replacement parts are listed in Figure 13. Parts other
than those listed in Figure 13 should be replaced by
Tyco Electronics to ensure quality and reliability of the
tool. Order replacement parts through your TE
ITEM DESCRIPTION
1 Support, Locator
2
Screw
Rev M
TOOL NUMBERS AND REPLACEMENT PART NUMBER
591 SHORT HANDLE 59275 SHORT HANDLE
59250 LONG HANDLE 59300 LONG HANDLE
---
---
Figure 13
Representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 1-717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
9. REVISION SUMMARY
Since the previous release of this sheet, the new
company logo was applied.
69692-1
LONG HANDLE
---
59755-1
---
1-21002-3
408-1610
69693-1 QTY PER
LONG HANDLE ASSY
59755-2 1
1-21002-3 2
11 of 11