Qsan XCubeSAN XS5224D Hardware Owner's Manual page 5

CE Statement
This device has been shown to be in compliance with and was tested in accordance with
the measurement procedures specified in the Standards and Specifications listed below.
Technical Standard:
UL Statement
Rack Mount Instructions - The following or similar rack-mount instructions are included with
the installation instructions:
1. Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than room
ambient. Therefore, consideration should be given to installing the equipment in an
environment compatible with the maximum ambient temperature (Tma) specified by the
manufacturer.
2. Reduced Air Flow - Installation of the equipment in a rack should be such that the
amount of air flow required for safe operation of the equipment is not compromised.
3. Mechanical Loading - Mounting of the equipment in the rack should be such that a
hazardous condition is not achieved due to uneven mechanical loading.
4. Circuit Overloading – Careful consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits might have
on overcurrent protection and supply wiring. Appropriate consideration of equipment
nameplate ratings should be used when addressing this concern.
5. Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct connections
to the branch circuit (e.g. use of power strips).
CAUTION:
The main purpose of the system left and right ears are for 19" rack use
only. Do NOT use those ears to carry or transport the system.
The ITE is not intended to be installed and used in a home, school or public area accessible
to the general population, and the thumbscrews should be tightened with a tool after both
initial installation and subsequent access to the panel.
Warning: Always remove all power supply cords before service
EMC DIRECTIVE 2014/30/EU
(EN55022 / EN55024)
iii
Notices